Foamiran (or plastic suede) is a material,in its properties resembling rubber. It is less durable, but very suitable for creativity and for creating beautiful realistic colors. It can be cut, heated, stretched and even dyed. From fojmirana it is possible to do a celebratory decor, bouquets of flowers and ornaments with roses and camomiles. In this article, we will tell you how to create a beautiful wreath from Foamiran with your own hands. You will need the following materials: plastic suede, scissors, oil paints or oil pastels, thick wire for the base of the rim and, of course, patience.
Of course, you will need to own fame. It is issued in sheets of different sizes by three countries - China, Iran and South Korea. As a rule, products made from fameiran are made from Iranian or South Korean material. In addition, it is better to buy thin sheets for flowers. To cut the foiaran, you need to buy sharp scissors and a clerical knife. Sometimes, to make the petals petite, the wizards use hot steam from the iron.
Take sheets of white, green and redcolors, aluminum wire with a diameter of two or three millimeters, brown teip-tape, red berries-billets, red satin ribbon and scissors. A similar wreath made of fameiran is made quite simply. First cut from the red, green and white leaves petals-droplets the size of one to three centimeters. The petals can be slightly toned, so they will look more natural. For toning it is better to take an oil pastel or oil paint. Acrylic paint can make the petals too hard.
Then, using an adhesive or thread with a needleconnect the petals together. Then take the wire and cut it into pieces with a length of 40-50 centimeters. The length of the wire will depend on the size of your head. Wrap the pieces of wire with a brown teip-tape, along with the red berries in the form of barberry. Twist the wire together, leaving a loop for the satin ribbon at the ends. Then, with a thread or glue, attach the roses to the base. Wreath from Foamiran is almost ready! You just have to cut off a little red satin ribbon and tie it to the loops.
To make such a wreath with purple flowers,you need plastic suede, wire, teip-tape or yarn, beads with a diameter of five to six millimeters, a satin ribbon of purple and paint for dyeing. First, draw a flower pattern with four petals on paper. Then cut it out. Next, attach the template to the foyamir and cut out the required number of such flowers. On average, one to ten beads leave from ten to thirty flowers.
Then tint the flowers with paint or pastel andtreat them with steam from the iron. In the center of all the flowers make small holes. The basis for the rim can also be made from wire and tape tape. At the ends, leave the eyelets, then you will tie them to a purple or purple satin ribbon. Then take a thin wire. To attach the flowers to the base, you need to take a piece of wire, thread it into the bead, and then pass through the flower and fasten to the wreath. Make sure that the flowers are evenly distributed around the wreath. Once you have primed all the flowers and checked the reliability of the fastening, you can rewind the base for the wreath with a tap-tape. If you want a tape tape, you can replace the yarn of a suitable color. The yarn has several advantages over the tape: it is more durable and does not deteriorate from moisture.
Wreaths made from plastic suede, likeother handmade products need to be properly stored and handled. First, do not leave a wreath of fameirana for a long time in the sun. Otherwise colors may fade. Secondly, it is desirable that products from the foyamir are well packaged. So you not only can avoid accidental pollution, but also protect flowers from crushing.
We hope that our article was useful for you, and you understood how to create beautiful ornaments on your head with your own hands.
