Probably, many of us can not manage a day withoutwatching television. News, any interesting programs and programs - all this became commonplace for us. And of course, all this can not be broadcast without an antenna. Buy such a device can be in any store at an affordable price, but if you have a few extra tins, a pair of meters of a television cable and a soldering iron, you can do it yourself. Yes, it is from such tools that today we will learn how to make such an apparatus as the DMV antenna.
To begin with, we need to prepare allassociated devices and mechanisms. In addition to two cans, a soldering iron and a cable, we will need more scotch, plugs and a wooden trembler. Together, of all these mechanisms, a perfectly normal, and most importantly, functioning antenna will be obtained.
In the question of how the antenna of thehands, you must first pay attention to the cable. We need to improve it a little. To do this, you need to make a small incision on its soft shell. Under it you will see something like silver foil. It is just the cable. So, the top layer of it should be cut about 10 centimeters from the edge, and then twist the foil and cut off its center by 1 centimeter. In this case, the other end of the device must be connected to a plug, which must then be connected directly to the TV.
Now we take up our "capacities". It is important to observe that the volume of tin cans is at least 700 and at most 1000 milliliters. When you cut their upper part, do not throw away or tear off the keys, as they may still be needed in our work.
To the antenna DMV, made by myself,normally functioned, to carry out the following steps, treat with special care and attention. Now we need to connect all the prepared devices (namely banks and cable with a plug) into one. The cord should be connected to the tin container in such a way that the foil is directly attached to the metal surface of the can. Next, you need to use an adhesive tape or, best of all, an insulating tape for the reliability of the fasteners. Of course, we can not guarantee an impeccable connection, but there are simply no other methods, for the use of a welding machine will simply burn the thin wall of our container. The only thing you can try is to connect using a soldering iron. Further, for the DMV antenna, made by hand, had a good reception quality, it is necessary to screw the cable elements to the keys.
Now we fix the jar on the trempel (again withusing an electrical tape) and connect the cable with a plug to the TV. It is important before this to find the best point of reception. If this is a private house, the DMV antenna with its hands is installed on the roof, if the apartment is on the balcony. It is in these places, as practice shows, the best reception points of the signal.
